What causes bubbles in a vinyl wrap?

Bubbles are air or moisture trapped when it was fitted. Creases are film that was stretched badly. Neither is damage to your car. Small bubbles in new film often settle out on their own within a few days.

What kind of repair does it need?

Small bubbles can be pricked and pressed flat by an installer. Creases and big bubbles mean that section of film is taken off and refitted, because a stretched crease will not go back.

Class of work The edge worked back down, or that panel's film replaced.

Caught early, with the surface clean underneath, an installer lays the edge back down. That is a small job. Once dirt or water gets well in, or a crease has stretched the film, that section is replaced.

What to do next

This is an installation fault, not wear. Go back to whoever wrapped it and ask them to fix it. If the wrap is only weeks old, give it a couple of weeks in the sun first.

Sources

  1. 3M Wrap Film Series 2080film makerUse an air release tool to…
  2. OZWRAPS (Australia)film installerThe most common cause is trapped air during installation.
  3. TeckWrapfilm sellerMostly, you can make it up if the problem is not too severe.

Not sure what your car damage is?

Point your phone at it, or describe it. The answer in seconds, $8 AUD.

Check it

Related

What is a scuff on a vinyl wrap? A scuff in vinyl wrap has not reached your paint. Learn when warmth helps, when scratches stay, and when to replace the film. What is a torn vinyl wrap? Once vinyl is cut or torn it cannot be repaired invisibly. Learn about patching vs panel replacement and batch matching. Why is my vinyl wrap lifting at the edge? Wrap lifts at edges when the seal fails or a pressure washer finds it. Learn why acting this week saves money. Why is my vinyl wrap fading? Vinyl fades unevenly because horizontal panels take more sun. Learn about film quality, warranty, and replacement.
← All damage types
Check it